I can't insert a node with the connections macro

I can't insert a node with the conncections macro

This article explains how to solve the problem when connections macro does not allow the insertion of a node into TecnoMETAL.

Problem

During use of the connections macro, the node is not inserted or the operation is not completed correctly.

Possible cause

The problem can be caused by:

  • geometric data entered incorrectly;
  • parameters not compatible with each other;
  • incorrect position of the beam or column.

Solution

Check the following points in the order indicated.
1. Try a node already in the database
Select a node already available in the TecnoMETAL database and check whether the insertion runs correctly.
If the node is inserted, then change only the parameters you need to adapt it to your needs.
2. Check the position of the beam
Make sure that the beam both inserted on theWire 1.
3. Check the location of the column
Make sure that the column both inserted on theWire 2.
4. Repeat the insertion of the knot
After performing previous checks, try inserting the node again through the unions macro.

Info

In most cases the problem is due to incorrect geometric data or the position of the beam and column compared to the reference wires.

Prevention

When you create a new node, we recommend starting from a node already in the database and change only the necessary parameters. This reduces the risk of configuration errors.

FAQs

Why is the node not inserted?
Generally because one or more geometric parameters are incorrect or because the beam and column are not placed on the wires provided by the macro.
Do I always have to create a new node?
No. We recommend using a node already in the database and edit it according to your needs.
What is the correct position of beam and column?
  • Beam:Wire 1
  • Column:Wire 2
The one of theproblem continues even after controls
If, after verifying all previous points, the node continues not to be entered, please contact the Steel&Graphics service by attaching, if possible:
  • the version of TecnoMETAL;
  • a screenshot of the connection;
  • a screenshot of the error message (if any);
  • the drawing file, if required by the support service.